Mine also developed like many wrinkles on both sides.

 

You mean something like this? (see pic below)
This is caused by improper installation where the surface was not completely dry, or has not been pressed well all around the sticker's edge, so humidity entered behind little by little. A good pushing is needed all around the sticker's edge during installation in order to avoid humidity entering behind ...as per instructions here and here

Important advice: if you are not sure about how you did push the edge properly during installation and glue has not been affected by humidity so far, please check/do it again now. Get a little spoon and push it slowly but hard enough all around like this

 

Almost like the thing your cup is sitting on... I don't really mind as long as the orange is covered up.

 

But if you make it again, I would probably get another set!

 

I do mind, I'll send you 1 set for free when I have time, just be patient ...and take care with the new installation

 

Already answered

There are some 3-4 pairs left with small faults ...not too visible, but looking way much better than my couch

 

Nick - My stickers have started to get wrinkled too. I don't know if it was the improper installations or a combination of cold and rainy weather. Anyway, I still have an extra one for the left hand side (if you remember back then, I asked for one). But I need to get another one for the right side. Please let me know when you start making them again. Thanks.

 

yes nick mine to are starting to wrinkle and bubble up....when i applied them to my car they were perfect....no visible sign of wrinkles or bubbles...now they looks worst and worst everyday...what can cause this to happen.....and also plz let me know if your going to be making anymore....i really need to buy a replacement or a back up pair

thanks!!

 

Oh well guys...

any other guys from the first bunch of stickers have had something similar or even someone that still have them on without this kind of issue?
I'll start thinking that something on the surface like wax or kind of chemical can't be completely wiped-out with just only good washing. Maybe a "wax removing" solvent is needed in some cases

 

PMd NIck