When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
your mode should be base in easy connect. Don't worry about the above post for now
Will try this today Sean, I was always under the impression that Base mode is for communication via OBD which is a BIG no for updating peripherals on MOST bus. Probably I am misinformed.
I spent sometime again today to get my ICOM-B being recognized with no luck.
As Sean suggested, tried setting EasyConnect to REMOTE:Base and locked ICOM, but as soon as I load PABD and P-SGBD, it spits out error below
So, I swtiched it to REMOTE:MOST_ASYNC_ab625 and locked ICOM and again the below error shows up as soon as I enter ECU address 63
Here is the software version of my CIC as read by EasyConnect
I mean this is not rocket science, I am sure there must be something simple that I have been missing all this time. If someone can just help me out in connecting successfully and communicate via ICOM-B, thats all I need. I have all the required tools, both hardware and software and I have done quite a bit of normal coding barring Most bus. Just missing hands on experience using these software tools. I am still being optimistic that this can be resolved.