b00sted415

Thanks!

matttytn2

FSW_PSW.Txt

i didnt mean to paste that oops, omg sorry seem i am past time limit to edit sorry mod pls remove last post.
(correct thats not from my car was looking up translations on the net and one link opened that trace file. )

here is what i coded to my lma module to turn off led errors cold check (strobe) and the key pathway lighting got rid of the number plate leds the outer angels and the fog lights leds but still got the inner angels strobe and appearing in the idrive

file attached at top

are these the inner angels?

ARMUEBERWACHUNG_AL_L
aktiv
WARMUEBERWACHUNG_AL_R
aktiv

nomis_nehc

Do you have halogen headlights? The E60's angel eyes for xenon headlights are powered by one bulb per side, so it's either strobbing for both or not.

As a note, AL refers to low beam.

matttytn2

that will be it then. low beam l and r i have halogen and my angels are 2 separate wedge bulbs each side

LéonGS

Hi to everybody!
I write from italy and I'm new to this forum, i got there thanks to this thread.
I'm really interested in coding the car the way you did.
I tried everything you guys did, but i still can't make in work.
I have a 09/2004 car with a regular key. Can anyone help??

thank you very much!

gt3

awesome, thank you for sharing!

henny

Hello,

Not sure if this was mentioned already.

If you set "HEIMLEUCHTEN_ABBRUCH" to aktiv, you can turn the pathway lighting off and on from the remote.

nomis_nehc

Oh cool, thanks for the input Henny. I wasn't aware of that. I imagine it's disabled by pressing the trunk button again? I'll test it out when it stops raining

nomis_nehc

I just had the chance to test out what henny said. Basically if you set HEIMLEUCHTEN_ABBRUCH to aktiv, when you turn on pathway light via key, it'll just shut it off immediately. So essentially, this is worthless unless you don't enable pathway lighting by key, and instead use the stalk to activate, and key to deactivate.

In short, you CANNOT turn on AND off of the pathway lighting via key. And just to add, abbruch means translation, so basically what's happening is it turns on and then off right away if you set both entries to aktiv.

bakhtiyar

545Felix where did you change the HEIMLEUCHTEN_KL58G_1 to active I couldn't find it in the LMA but I found some interesting parameter in the Car FSW_PSW file , I mean the file that you get when you press back button in NCS expert . Someone says it's the backup of your car configuration but I found the HEIMLEUCHTEN_KL58G_1 in that file which does not exist the LMA, my question is that can I change the parameter in that backup file and write it to the car . Thanks in advance.