madein

Did you read the module again, to confirm changes have been made?

bmwfive

yep

Ehssan

in RLS module

FLC_SCHWELLWERT_SATZ
wert_01]
wert_04] = sensitive

wert_02 = normal
wert_03 = very sensitive

1+4 = sensitive , when you change it to 2 it will be less sensitive but still acting strange for some reason ,, I found it in my M5 acting according to the speed , I have a tunnel which I ( used to ) pass through everyday going to work ,, if I drive slowly ( because of some stupid driving slowly ) the lights comes on in the middle of the tunnel , if I drive fast , the lights comes in as soon as I enter the tunnel ..

Madein , you are lucky , I found those in my netbook , very strange as I didn't ready did much of coding on my netbook , all the stuff are on my laptop back home ..

anyways hope it helps you ..
LM2 trc original.txt
NETTODAT .txt

nomis_nehc

Odd that the light sensitivity isn't working right for you guys. It's working great for me. I waited almost a week to post my experience just to make sure too.

bmwfive

So should I have changed it from:

FLC_SCHWELLWERT_SATZ
wert_01
wert_04

to:

FLC_SCHWELLWERT_SATZ
wert_01
wert_02


...When I coded it yesterday, I actually changed it to:

FLC_SCHWELLWERT_SATZ
wert_02

madein

thanks a lot

madein

This is correct, only value wert_02, the rest just need to be deleted

Now, if you can't see any changes in the sensor behaviour, try from beginning.
Sunny day, car in the shadow reverse the changes back to:

FLC_SCHWELLWERT_SATZ
wert_01
wert_04

read it back to confirm and you will see, if the lights are coming ON, than change to:

FLC_SCHWELLWERT_SATZ
wert_02

and I'm sure, it will stay OFF, if it doesn't work, you have try progman

bmwfive

Ok I'll give this a go. The weather is wet and dull out at the moment so I'll have to wait for a sunny day.

madein

You can try now, if you have nothing to do, I'm sure, on the sensitive wert_1+wert_4 it will bring the lights ON and if you change to wert_2 should stay OFF

bmwfive

Are you coding CAS>RLS or LMA>RLS?

The only reason I ask is because I have done previous coding to bulb checks under CAS>LMA and this also didn't work. (I have been successful with the digital speedo, so coding is working)