For sale is a set of mtech front bumper foam and bumper brackets. This is the foam and brackets that are recommended when doing the mtech bumper swap. I ended up going with an m5 bumper and didn't need these. The parts were bought new, and test fitted. One peice of foam had two of the tabs broken when test fitting (in too much of a rush) but will still work fine. May need a small strip of double sided tape to fully secure the end. The rest of the parts are in new condition and were only on the car for about 2 minutes.

Looking to get $70 plus shipping.

 

Is this just for oem mtech bumper? As I am waiting for bumper from umnitza. And planning on doing a DIY

 

As far as I know, if you want to bolt the bottom front of that bumper up (both OEM and Umnitza/Trinity/etc) you will need the brackets. I have heard you might be able to "shave" the stock foam, but I wanted to do it properly and use the OEM foam so I didn't have to hack up my car.

 

Yes I have heard that. I'll do some research on the matter. Keep u posted. And thanks again