Dude did you say STD

 

In your eyes maybe....

 

what types of LEDS from radio shack do I need to get??

 

i wanna get this done on my car but my eye brow dont work is there a way to tell if the led are bad or it just the power i have a 545i

 

If you didnt find out, there is a very simple way to test this which anyone can do.
Send me a PM if you need to know and I will tell you how.

 

i did not find out how

 

i found out the led work fine but there no power going to it any ideas on wat it could be

 

Someone with NCSExpert can activate it for you. Or you can manually tap the wire so you get some juice going through there.

 

So I have done one side of my eyebrows and they look great at night. however, right where the LEDS are, the lense is fogged up a bit, any suggestions on how to fix it? Where I siliconed it, do I need to allow a little whole for ventilation? Any input would be appreciated!

 

Im no expert, but condensation on the inside is due to a small hole somewhere.

My advise would be to take it apart again, stick it somewhere warm (and dry) for atleast 24 hours, probably run a hair dryer over it for 5 mins then reseal it up properly (within a warm dry environment), and by that I mean not in a shed, garage or drying room.

HTH