Hello Everybody. I have a sticky question and I know some of you have experimented with this.
I have installed INPA on my PC and have DIS and SSS Progman installed as Virtual machines by WM ware.
I have operated INPA with a chinese made OBD 2 plug and Carsoft interface, but I have not suceeded running DIS or SSS.
My problem is that the program will not find the diagnostic head. The head could not be communicated with. I know for following some
old forums that this was at some time or the other maybe discussed here. Maybe some knowledgable forum followers can give me some
indication how to work with this head or any other tested head with defined settings.
any help appreciated.

 

You lost me at the first to sentences

But I am sure someone here will help you out...good luck!

 

I need all the luck I can get

 

Check out this site:
http://ecubb.bmwecu.org/board/index....7f2d186a517caa
These guys get down and technical

 

That site is useless unless someone give you an invitation code.

 

I am on that site, let me see if I can...

 

Before we may proceed, please verify your DIS and SS program versions. While you are there, also verify that your laptop port settings are configured and in sync with the settings in DIS. Report your discoveries, and we'll take it from there.

 

I can access this site without any code...just used the link provided

 

Ya, but you cant reg or post

 

yes, have been into and its interesting.
now let`s see the guy who was suggested will do.
I have already contacted him and will tell you all where this leads to..