DDE fault
06-17-2013 | 10:27 AM
#11
Thread Starter
New Members
Joined: Jun 2013
Posts: 6
Likes: 0
From: Altrincham
My Ride: 525 M Sport Touring (E61)
Called a couple of dealers today
One of them said my model doesn't have a DME relay but that they do stock a few relays and they are around the £14 mark.
I'm hoping this is the cause of the problem and that I can identify the part once I access the ebox.
Thanks for all the help guys
Keep it coming
One of them said my model doesn't have a DME relay but that they do stock a few relays and they are around the £14 mark.
I'm hoping this is the cause of the problem and that I can identify the part once I access the ebox.
Thanks for all the help guys
Keep it coming
07-16-2013 | 12:59 PM
#12
New Members
Joined: Nov 2010
Posts: 2
Likes: 0
From: Lithuania
Hey guys
First post here
After my car returned from having it's MOT done recently, I allowed it to run very low on fuel (0 miles on range comp). I immediately drove to the petrol station and put about quarter of a tank in. The car stood unused for about 4 weeks. Upon going to start the car I was met with a bank of faults including fuel pump errors. After taking advice from another forum I purchased the DIS software and lead and cleared the faults and tested again which left me with 2 faults CAN system analysis and EKPS fuel-pump control. I had a visit from a mechanic friend today who couldn't get his 5 grand Snap On computer to communicate with the car but after using DIS and investigating further, it's showing communication problems with DDE? I have popped in a new battery today but I cannot register it with the car as that too is having problems communicating and is showing a DDE error.
Any ideas?
Regards
Jonny
First post here
After my car returned from having it's MOT done recently, I allowed it to run very low on fuel (0 miles on range comp). I immediately drove to the petrol station and put about quarter of a tank in. The car stood unused for about 4 weeks. Upon going to start the car I was met with a bank of faults including fuel pump errors. After taking advice from another forum I purchased the DIS software and lead and cleared the faults and tested again which left me with 2 faults CAN system analysis and EKPS fuel-pump control. I had a visit from a mechanic friend today who couldn't get his 5 grand Snap On computer to communicate with the car but after using DIS and investigating further, it's showing communication problems with DDE? I have popped in a new battery today but I cannot register it with the car as that too is having problems communicating and is showing a DDE error.
Any ideas?
Regards
Jonny
Hi,
I had these problems ;] i had lots of them with E61 525d ;]
Just re-register new battery with INPA, thats ALL....
Thread
Thread Starter
Forum
Replies
Last Post