Hello. Just got 20s put on and fitment is perfectly flush with fenders. however the rear fenders will need to be rolled. inside is hitting just a bit over certain bumps.

Can someone tell me how much this normally costs? So i dont get ripped off.. I have few places I can go through.

 

There are posts here of people having them done about $40 per corner.

 

Double check to make sure your not rubbing the fender liner versus the actual fender. If it is the liner you can just remove it, heat that section up and push it out a bit to give you more clearance.

 

usually about 40~50 a corner
Make sure you go to a good reputable place though, some shops chip your paint from their lack of skills

 

+1

 

I think that is happening to my front wheel fender liner. I get a nasty scrrraattcchh noise when I go over big dips at freeway speeds. Do you have to actually remove the fender liner or can you just push the heated liner in with the corner jacked up?